• ExLisper@linux.community
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    No, what it should do is:

    • when timer ends or stop button is pressed it should turn off microwaves but keep spinning until original position
    • when door is opened just stop everything immediately

    This way you can stop the plate manually at any position but when operating microwave in the usual way you get the benefit of the cup always pointing the right way.

    • Ech@lemm.ee
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      when timer ends or stop button is pressed it should turn off microwaves but keep spinning until original position

      Better yet, change the rotation speed to match the timer.

      • ExLisper@linux.community
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        It would require variable speed motors and more complex chip and programming so it would be more expensive. Just spinning the plate at the same speed until it makes a full turn could be solved mechanically.

        • Ech@lemm.ee
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          I mean, sure, but there are microwaves out there that measure the heat of food put in it to cook it automatically. I figure a variable speed to match an input time would be just a bit easier to accomplish than that.

      • itsgallus@beehaw.org
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Have it calculate the amount of full rotations and round it down to the nearest whole number. Worst case scenario, your cup is static for 5–10 seconds before the microwave stops.